Hi all I recently bought a machine with an alarm 17-83 pnd opto blocked on it and wandering if there any tech guys out there who could help me source the problem?
I've taken the hopper apart, cleaned the sensors, put it back and yet still getting alarm.
I have cleared the alarm code and reset the logs..........
and even when the main hopper lead isn't plugged into main board it is still recognising fault?
How is this even possible when it isn't even connected?
I wandering now Ive cleaned it, if I maybe have a knackered opto sensor, or maybe the motor has packed up?
Would this still cause the same alarm code, whether it it the sensor, or anything else for that matter?
I know it points towards hopper, so does that necessarily mean it could be anything in that area?
Many thanks.